How to install an Entrance Hinge Door?
6 Steps assist you to get your front door install!! Super easy!
The front gate is the most important part of the house, it’s easy, but it’s also easy to install not good.
Here, we will like you to share some useful instructions and tips, to assist you to install an entrance steel door.
Step 1: Prepare tools
Necessary tools: Electric dill, screws, socket wrench, hammer, tape measure, level
Step 2: Outer frame installation
Clear the frame side of extra bricks (If is an old house), for the new house, directly install the frame into the hole, check the front and back fitting
Step 3: Position fitting confirm
Measure the horizontal position and vertical position for the frame fitting by tape measure and level (Must need !!)
This step is very important, because once the frame is lying, your whole door will not look good, and might change position once you get the whole install
Step 4: Frame fixing
Fix the patch with screw, on both left and right sides, and wrench the screw to tighten the frame for both sides.
Normally each side has 3 positions needed to fix the screw
Step 5: Door panel matching
Install the door panel into hinge matching, swing it for testing position
Step 6: Gap filling
Fill the frame side gap with cement for fixing, using walling to cover the loss part and finish.
Feedback with us for your installation idea or actual operate tips.
If you want to see more designs of the entrance door, leave us your mail or contact us directly, don’t forget to check below for other useful tips.
Our direct contact Whatsapp: +8615602302488
Leave a Reply